d22f196b Assembly of a cylindrical pin

Fig. 3.53. Installation of a new cylindrical pin

Establish a new cylindrical pin, as shown in the figure 3.53 to hold an axis of satellites.
Measure a gap according to the following procedure.
Establish the left and right power shafts in differential.
Support power shafts by prisms.

Fig. 3.54. Measurement of a gap of satellites

Measure a gap of both satellites (fig. 3.54).
Gap: 0,050–0,150 mm.
If results of measurements differ from norm, replace the worn-out and damaged details.