2.2.18. Assembly of a head of the block of cylinders
Install the case of output branch pipes of the cooling system.
Establish a recirculation tube.
- 1. Operation and maintenance of the car
- 2. Engine
- 2.1. General description of new engines of the L8, LF and L3 models
- 2.2. Mechanical part of engines
- 2.2.1. Engines of the L8 and LF models
- 2.2.2. Verification of the contents of CO/CH in the fulfilled gases
- 2.2.3. Measurement of a compression in engine cylinders
- 2.2.4. Check of a belt of the drive of auxiliary units
- 2.2.5. General information and safety measures at removal of the power unit
- 2.2.6. Removal of sealant
- 2.2.7. Removal and installation of the power unit
- 2.2.8. Check of the executive mechanism of change of phases of gas distribution (L3)
- 2.2.9. Removal and installation of the executive mechanism of change of phases of gas distribution (L3)
- 2.2.10. Gas distribution mechanism drive chain
- 2.2.11. Removal and installation of the operating oil valve (OCV) (L3)
- 2.2.12. Check of the operating oil valve (OCV) (L3)
- 2.2.13. Check of operation of the spool-type valve (OCV) (L3)
- 2.2.14. The general repair operations on the power unit
- 2.2.15. Check of a head of the block of cylinders
- 2.2.16. Assembly of the block of cylinders (beginning)
- 2.2.17. Assembly of the block of cylinders (termination)
- 2.2.18. Assembly of a head of the block of cylinders
- 2.2.19. Assembly of the drive of the mechanism of gas distribution
- 2.3. Appendix 1
- 2.4. Appendix 2
- 2.5. Appendix 3
- 2.6. The Z6 engine – a mechanical part
- 2.7. Lubrication system
- 2.8. Cooling system
- 2.9. System of an admission
- 2.10. Fuel system
- 2.11. System of production of the fulfilled gases and system of decrease in toxicity
- 2.12. System of ignition
- 2.13. Control system
- 2.14. Tables
- 3. Transmission
- 4. Running gear
- 5. Steering mechanism
- 6. Brake system
- 7. Onboard electric equipment
- 8. Body
