Fig. 5.34. Installation of a clip of the pump of the hydraulic booster

Put on a clip in the direction shown in the figure 5.34.

Make sure that the ear of a clip is recorded.

Fig. 5.35. Installation of an epiploon in a forward pump housing

Establish an epiploon in a forward pump housing, using special adaptation and the kapron hammer (fig. 5.35).

Fig. 5.36. Assembly of blades

Place blades in a rotor so that the rounded edges were included into a cam (fig. 5.36).

Fig. 5.37. Installation of a statorny ring in a forward pump housing

Establish a statorny ring in a forward pump housing by a tag (fig. 5.37) up.

After installation of the back case manually turn a shaft to check smoothness of rotation.

Establish a shaft in a forward pump housing.

Install the pump and tighten three bolts of fastening.

Install pressure sensor socket.

Establish a driving belt.

Pump over a hydraulic contour of the steering mechanism.

Check whether there is no leak and dribble of working liquid of hydraulic system.

Make check and installation of a steering wheel.