Fig. 2.130. Removal of a back epiploon of a bent shaft: 1 – bolts; 2 – epiploon

Turn off six bolts of fastening of a back epiploon and remove an epiploon (fig. 2.130).

Fig. 2.131. Places of putting sealant

Apply kremniyevoorganichesky sealant on the interfaced surfaces in the place shown in the figure 2.131. Diameter of a point of drawing 0,4–0,6 mm.

Apply pure engine oil on a working edge of a new epiploon.

Fig. 2.132. Scheme of installation of a back epiploon of a bent shaft: 1 – bent shaft; 2 – back epiploon; 3 – device for installation; 4 – block of cylinders

Establish and press a back epiploon, using the device for installation of a detail, as shown in the figure 2.132.

Fig. 2.133. Order of tightening of bolts of fastening of a back epiploon of a bent shaft

Tighten bolts of fastening of a back epiploon in the order specified in the figure 2.133, the moment of an inhaling of 8,0-11,5 N · m.